M. MARCOMori, ItalyVerified Buyer5 of 5All okayJacques P.Troistorrents, SwitzerlandVerified Buyer5 of 5Easy to installBernard RECHUROQUEFORT LA BEDOULE, FranceVerified Buyer5 of 5Product conforms so RAS and good delivery tracking!Flavelle ScottMount Currie, CanadaVerified Buyer5 of 5Quick delivery from the US to Canada and exactly as ordered.
Flawless shopping experience!
My tip to install, use a fairly big set of those quick adjust pipe wrench that opens to 2” gap or so.
Just press them into position and use them to get the old ones half way out. Easy peezy.Kenneth LindenIrvine, United StatesVerified Buyer5 of 5The Marker U springs arrived faster than expected, and are exactly as advertised.Archie GilliesAberdeen, United KingdomVerified Buyer4 of 5Completely agree with Karol below. Nightmare to install. Had to file the inner edge a bit to get them on, after various failed attempts started to chew up the plastic/carbon body of the binding. The cut ends of the springs are pretty unrefined and could do with a bit of filing before they leave the factory. Once on, they work fine, I'm sure, and I got a swift and sensible reply from Skatepro when I asked for advice, so overall a positive experience. Would certainly use this retailer again.Maria GłowackaZabrze, PolandVerified Buyer5 of 5Efficiently and quickly handledKarol S.Northport, United StatesVerified Buyer4 of 5Have not had a chance to test them, not enough snow yet, but have no reason to believe they would not work. Got them to replace the "hard" DIN 12 bows that came with my bindings. They certainly were a bitch to install though. Not like the manufacturer describes it, just remove the small screw and slide it out/slide it in. The prongs are not quite parallel but rather convergent a bit. At the end I managed to spread them a little by forcing a suitable size of a socket wrench in between of them.BOUNET LucDONNEVILLE, FranceVerified Buyer5 of 5Fast and compliant product. Perfect.XAVIER MARTI IGUALRUBI, SpainVerified Buyer1 of 5The shipping of the product was impeccable. As for the product itself, the assembly of the product in the binding is much more complicated than it seems. In addition, the instruction booklet does not clarify this point. Negative review for MarkerReply from SkateProWe regret your bad experience with the product. Please contact us so that we can advise you on how to mount it if you have not yet succeeded :-) Best regards / Soraya
