Instructions for Installing Turnamic IFP Bindings

This video demonstrates the process of fitting Turnamic bindings onto IFP plates. The system necessitates sliding the bindings onto the mounting plate:

1. Begin by joining the rear section of the binding with the front section.
2. Configure it to match your boot size.
3. Subsequently, release the binding using a small switch found on the front section.
4. Then, glide the binding onto the mounting plate.
5. You must fit both the front and rear sections simultaneously.
6. At this point, you can adjust the position of the binding.
7. The final step involves securing the binding in place.

Your bindings are successfully installed!